![]() ![]() Note that most traffic is passing over the default route, while the subnet specified in the command ( 10.10.0.0/14) is passing over the tunnel. Tried to install Cisco An圜onnect on my personal computer (I have admin rights) as I need it for work. An圜onnect macOS 11 Big Sur Advisory An圜onnect macOS 11 Big Sur Advisory 0 Helpful Share Reply Karsten Iwen VIP Mentor Options 11-25-2020 02:10 AM From the release notes: An圜onnect 3 New Features This An圜onnect 3 release introduces support for macOS 11.x (Big Sur) and compatibility with devices running Apple Silicon. Your routes after this command will end up looking something like # ip routeĭefault via 10.1.1.1 dev wlp4s0 proto static metric 600ġ0.1.1.0/24 dev wlp4s0 proto kernel scope link src 10.1.1.50 metric 600ġ0.10.0.0/14 dev tun0 scope link metric 6ġ80.10.34.165 dev tun0 scope link metric 6 You only need to add the new profile, as shown in the remaining steps. Where 10.10.0.0/14 should be the subnet you'd like to have pass through the VPN. Note: If you are currently using An圜onnect for another VPN, you do not need to reinstall the application. Then you'd follow the instructions in this github gist. ![]() You'd also need vpnc-script in order to make the process of setting up routes a little easier (although you can always manually go back afterwards and use the ip route commands). ![]() If you make use of an alternate client, openconnect, split tunneling is fairly straightforward. I can only address the first part of that question, "would it be possible to setup a linux VM. Barring that, would it be possible to setup a linux VM with an HTTP/S proxy and SSH that route over the VPN tunnel? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |